Q: What is the difference between these and the "Boss" version?
A: The only difference is the "Boss" end cap.
Q: do you sell replacement parts, I was installing a set of your heated grips and broke the wires off inside the throttle grip its a push pull custom contour
A: No sorry we do not because the wiring is attached to the heater pad that is in between the grip & tubes so you can't fix it. You can just buy the heated grip only from us by calling our Customer Service dept. at 800-334-7477.
Q: What year's will your heated grips fit ? Pre 96 ?
A: If your bike is listed on the fitment chart then our heated grips will work on it. If your bike isn't on the push-pull list then we have no idea because we haven't tested our grips on bikes older than what is on our fitment chart.
Q: Hello, I have a set of the Black Custom Contour Anodized Heated Grips and need to replace the rubber on them, how can I go about getting new rubber for them? If I can get new rubber, what is the best method for changing it?
A: Sorry because the heater pads are in between the rubber of the grip and they throttle/clutch tubes we are unable to cut off the rubber without damaging the heater pads so we cannot change out the rubber on any heated grips.
Q: Can the wires be cut and lengthened, for internal wiring on ape hangers, without damaging anything?
A: Yes they can be cut and lengthened.