Q: Will these grips fit a 2013 victory cross-country tour I'm not looking for heated grips
A: No this grip is for Harley Bikes. You need to go the Metric Cruiser section on our website to see the heated grips that will work on your bike.
A: You can move your throttle housing towards the grip if it is too short.
Q: Can you move the Throttle Assist to any position up or bottom to set up? Is it possible to replace the cap with Anodized Long Spike for Air Cushion cap?
A: Yes you can but you have to have grip off the handlebar. There is a Phillips head screw down the center of the grip that holds all our end caps on. After loosening screw move Throttle Assist to position you like. You will need to put a few drops of blue Loctite on screw when reinstalling end cap. Make sure you hold the end cap in the position you like before you tighten screw back up.
Q: Hi, I recently got the G2 ergonomics sleeve. How can i remove the stock sleeve from this grips and install the g2 sleeve? Thanks
A: As far as we know you can't just remove the throttle tube to switch out to a g2 sleeve. You would have to cut off the rubber and disassemble the caps & collar.
If you send your grips and g2 sleeve to us and you pay for shipping back and forth we can fix you grip with new rubber for $20 which includes the shipping back.
Q: 2003 Honda VTX 1800C. Can't find grips with the proper fitment. They all seem to be too big around where the 2 throttle cables connect. HELP !?!
A: Our metric grips work on your bike. You have to make sure you are using the "A" cam that is for Honda's and the letter needs to be facing the grip when you install it.